5.2
Connecting to LAN with Port-Pair Redundancy
The LAN ports are provided on the CRMX and SWX LAN Expansion modules (see Section
3.1.6
on page
pairs (groups) to provide LAN port 1+1 redundancy. In each pair, one port serves as the
active LAN port while the other as standby. When the active port fails, the device switches
to the standby LAN port.
Note:
The figure below shows the LAN port-pair groups and the name of the ports and groups as
displayed in the Web interface for configuring the port groups and assigning them to IP
network interfaces (refer to the User's Manual for more information):
Figure 5-2: LAN Port-Pair Groups and Web Interface String Names
An RJ-45 cable connector with the following pinouts is used:
Hardware Installation Manual
22
and Section
3.1.7
on page 24, respectively). These LAN ports operate in
The SWX module is a customer ordered item.
Figure 5-3: RJ-45 Connector Pinouts for LAN
Mediant 1000B Gateway & E-SBC
30
Document #: LTRT-41401