Table A-5: Osn3 Module Leds Description - AudioCodes Mediant 1000B Hardware Installation Manual

Item Label
1
2
3
4
5
6
7
8 SPEED
Hardware Installation Manual

Table A-5: OSN3 Module LEDs Description

Color State
Green Flashing
Red On
3 Red On
Flashing
- Off
2 Red On
Flashing
- Off
1 Red On
Flashing
- Off
0 Red On
Flashing
- Off
Blue Flashing
On
Off
Red On
Flashing
- Off
Green On
Yellow On
- Off
Mediant 1000B Gateway & E-SBC
Description
Hardware normal operation
Hardware fault (over-temperature or excess
voltage feed).
When lit during boot-up, indicates power failure.
Processor over-temperature above 100°C. If LEDs
0, 1, and 2 are also flashing, there is a processor
over-temperature above 125°C and as a result,
the module shuts down.
Normal operation.
When lit during boot-up, indicates clock failure.
Chipset over-temperature above 105°C. If LEDs 0,
1, and 3 are also flashing, there is a processor
over-temperature above 125°C and as a result,
the module shuts down.
Normal operation.
When lit during boot-up, indicates a hardware
reset.
Processor over-temperature above 125°C and as
a result, OSN3 shuts down (if LEDs 0, 2, and 3 are
also flashing)
Normal operation.
When lit up during boot-up, indicates a BIOS boot
failure.
Processor over-temperature above 125°C and as
a result, OSN3 shuts down (if LEDs 1, 2, and 3 are
also flashing)
Normal operation.
Module undergoing shutdown sequence when
module pulled out to first extraction position.
Module shutdown sequence complete and the
module can be extracted from the chassis slot.
Module correctly inserted in chassis slot.
Hardware failure (supplied voltage is not within
normal operating range – ensure CRMX is
installed in chassis).
Upgrade in progress
Normal operation
100Base-TX connection
1000Base-T connection
10Base-T connection if ACT LED active
52 Document #: LTRT-41401