Figure 6-6: Module Orientation In Top And Bottom Chassis Slots - AudioCodes Mediant 1000B Hardware Installation Manual

To replace I/O modules:
1. If you are replacing the CRMX module, power down the device, and then skip to
Step 3.
2. Software-remove the module, using the device's Web interface's 'Home' page (refer to
the device's User's Manual).
3. Disconnect the cables from the module that you want to replace.
4. Physically remove the module from the device's front-panel slot, by performing the
following:
a. Using a flathead screwdriver, loosen the module's two mounting screws.
b. Gently extract the module from the slot.
5. Physically insert the new module into the same slot from where the module that you
are replacing resided, by performing the following:
a. Insert the module into the empty slot, with the orientation of the module as
follows:
♦
♦

Figure 6-6: Module Orientation in Top and Bottom Chassis Slots

b. Align the module with the slot rails.
c. Gently push the module into the slot and press on it firmly to ensure it has been
fully inserted.
d. Using a flathead screwdriver, tighten the module's mounting pins.
6. Reconnect the cables to the module. If you are replacing the CRMX module, skip to
Step 8.
7. Software-insert the module, using the device's Web interface's 'Home' page (refer to
the device's User's Manual).
8. If you have replaced the CRMX module, power up the device's chassis.
Hardware Installation Manual
Top-row slots: ensure that the module is orientated such that the port
number labels are located at the bottom of the module's front panel. This
module orientation is considered as facing up.
Bottom-row slots: ensure that the module is orientated such that the port
number labels are located at the top of the module's front panel. This module
orientation is considered as facing down.
Mediant 1000B Gateway & E-SBC
46 Document #: LTRT-41401