Connecting To Fxs Interfaces; Figure 5-4: Rj-11 Connector Pinouts For Fxs - AudioCodes Mediant 1000B Hardware Installation Manual

5.3

Connecting to FXS Interfaces

The procedure below describes how to connect to FXS interfaces such as fax machines,
modems, and plain old telephone system (POTS) telephones.
Warnings:
Note:
An RJ-11 cable connector with the following pinouts is used:
To connect to FXS interfaces:
Using an RJ-11 connector, connect the FXS port/s to the required telephone interface.
Hardware Installation Manual
•
Ensure that FXS ports are connected to the appropriate external devices;
otherwise, damage to the device may occur.
•
The FXS ports are considered as TNV-2.
The FXS module is a customer ordered item. This section is applicable only if
your device is installed with such a module.

Figure 5-4: RJ-11 Connector Pinouts for FXS

Mediant 1000B Gateway & E-SBC
32 Document #: LTRT-41401