Analog Interfaces; Connecting To Fxs Interfaces - AudioCodes Mediant 1000B Hardware Installation Manual

Gateway & enterprise sbc

Hide thumbs Also See for Mediant 1000B:

Table of Contents

Hardware Installation Manual

5.3

Analog Interfaces

This section describes the cabling procedures for analog interfaces.

5.3.1

This section describes how to connect the FXS interfaces to FXS equipment such as fax

machines, modems, and plain old telephone system (POTS) telephones. FXS cabling can

be routed indoors or outdoors, depending on the FXS module used (see Section

page 17).

Warnings:

•

FXS modules for indoor cabling: The FXS port interface cabling must be routed only

indoors and must not exit the building.

•

Make sure that FXS ports are connected to the appropriate external devices;

otherwise, damage to the device may occur.

Avertissements:

•

FXS module intérieur: Le câblage de l'interface du port FXS doit être acheminé

uniquement en intérieur et ne doit pas sortir du bâtiment.

•

Assurez-vous que les ports FXS sont connectés aux appareils externes appropriés ;

autrement, vous risquez d'endommager l'appareil.

Note:

The FXS module is a customer ordered item. This section is applicable only if your

device is installed with such a module.

Media Gateways & SBCs

Mediant 1000B Gateway & E-SBC

5. Cabling the Device

3.2.1

Table of Contents