Drive System; Removing The Pick-Up Motor Unit; Removing The Feeder Motor Unit - Canon FY8-13FW-000DADF-A1 Service Manual

CHAPTER 3 MECHANICAL SYSTEM
II. DRIVE SYSTEM
A. Removing
Motor Unit
1) Remove the body cover.
2) Remove the tie-wrap as necessary.
3) Disconnect the connector J12 [2] from the
DADF controller PBC [1].
[1]
Figure 3-201
4) Remove the screw [3], and remove the
cable guide [4].
[4]
Figure 3-202
3-6
COPYRIGHT © 1998 CANON INC.
the Pick-Up
[2]
[3]
CANON DADF-A1 REV.0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
5) Disconnect the connector [5] of the upper
cover sensor S4.
6) Remove the two mounting screws [6], and
detach the pick-up motor unit [7].
[5]
[6]
[7]
Figure 3-203
B. Removing the Feeder Motor
Unit
1) Remove the pick-up motor unit.
2) Remove the tie-wrap as necessary.
3) Disconnect the connector J11 [2] from the
DADF controller PCB [1].
[1]
Figure 3-204
[6]
[2]