Optional Features; Climate Control Unit - World Cat 2009 boat Owner's Manual

World cat boat

Hide thumbs

Table of Contents

GENERATOR

The Fischer Panda™ generator is installed under the starboard lounge seat, and can be accessed using

the hatch located on the seatbox or by removing the tackle unit on the aft vertical wall. For rigging infor-

mation, review pages 19 and 20 of this manual. Prior to using the generator, review the manual provided by

Fischer Panda™ which is included in your "Owner's Portfolio". Follow these startup guidelines before

each use of the generator:

Verify that the seacock located in the port aft bilge compartment is open.

Verify that the "Port Start" battery switch is "ON".

Turn off the "Ship Power" breaker and all accessory breakers located on the AC Panel

Press the "ON" button on the generator control panel, located on the aft cabin wall, and wait for the

unit to perform its self-test. If the LCD screen displays "00000" then proceed to step 5. If an error

message is displayed on the LCD screen, do not attempt to start the unit. Contact your dealer and

schedule a maintenance check.

Use the start button on the control panel to crank the generator.

If the generator does not start within the first three attempts, turn the panel off and contact your

dealer prior to further use. Failure to do so, will result in significant damage to the generator.

Once the generator is running, engage the "SHIP POWER" circuit breaker and verify that the

"REVERSE POLARITY" indicator is not lit. If it is not lit proceed to step 7, however, if the red

LED indicator is lit, immediately turn "OFF" the "SHIP POWER" breaker and shut down the gen-

erator. Notify your dealer regarding the issue and have a trained electrician inspect your boat to

determine if any damage has been sustained by the electrical system.

You may now engage the AC accessory breakers.

Routine maintenance should be performed on this unit using the guidelines established by Fischer

Panda™. Failure to comply with these guidelines will result in loss of warranty coverage and creates the

potential for property damage or personal injury.

CLIMATE CONTROL UNIT

The heating/air conditioning unit is mounted under the port lounge seat. It can be accessed by remov-

ing the removing the bulkhead located above the quarter berth on the port side of the cabin.. The filter con-

trol panel are located in this bulkhead. Follow these startup guidelines before each use of the unit:

Verify that the seacock located in the port aft bilge compartment is open.

Using the guidelines provided, energize the AC panel using the generator of shore power connection

and engage the corresponding circuit breaker.

Using the control panel, energize the climate control unit and select the operating mode and desired

temperature using the selection tools. This will engage the raw water pump located in the port aft

rigging compartment.

Once the unit is running, inspect for water flow through the system by checking the thru-hull

located on the port sponson (see Thru-Hull drawing page 23). If water is not flowing, shut down the

unit immediately to prevent damage. Then have your dealer inspect the system.

Similar to a residential system, the filter units must be replaced at regular intervals to ensure proper

operation. Use the manual provided in your "Owner's Packet" to obtain requirements for service, and to

get recommendations on usage.