Initial Start-Up; Normal Use; Deck Pump-Out Procedure; Overboard Discharge Procedure - World Cat 2009 boat Owner's Manual

World Cat
INITIAL START UP
On each trip, prior to using the head, complete the following steps:
1. Turn on the freshwater system.
2. Fill 1/3 of the bowl with water by lifting up on the flush lever
3. Hold down the flush lever for 5 seconds to evacuate the bowl.

NORMAL USE

Use the steps below for normal operation.
1. Fill 1/3 of the bowl with water by lifting up on the flush lever
2. Hold down the flush lever for 5 seconds to evacuate the bowl.
Large quantities of waste or paper can clog the head and cause odor issues. To prevent this, flush
often and if necessary perform an extra flush to purge the discharge line.
Do not dispose of foreign objects in the head. Doing so may damage the outlet hoses. Clogging or
DECK PUMP-OUT
Upon returning, use the following instruction to empty the holding tank.
1. Remove the cap from the deck pump-out fitting located on the deck, forward of the star-
board fuel fill.
2. Use the vacuum hose at the pump-out station to clean the tank, then remove the hose and
replace the deck fitting.
OVERBOARD DISCHARGE
Use the following steps to discharge the contents of the holding tank overboard:
1. Remove the access plate located behind the head to open the discharge seacock.
2. Using the TankMaster™ panel, turn the key switch to "manual" to engage the macerator
pump. Hold the key in this position until the Tank Watch™ panel reads empty.
3. Close the discharge seacock and replace the access plate.
Discharging waste in inland waters and some coastal areas is illegal. Check with local and state
authorities in your region to determine the proper method for waste disposal.
For more instructions on operation, winterization and troubleshooting the marine head, see the Vacu-Flush™
! CAUTION
! CAUTION
puncturing these lines will lead to odor problems.
! CAUTION
manual supplied in your "Owner's Portfolio".
5-8