Cockpit Drains; Winterization - World Cat 2009 boat Owner's Manual

World Cat

COCKPIT DRAINS

All World Cats have four drains located in the cockpit, two on both the starboard and port sides. These
drains are designed to quickly evacuate the cockpit should the boat become swamped. Flushing these
drains routinely will ensure the safety of your crew and vessel, as well as, eliminate the potential for odors
associated with fish residue. These drains are evacuated through the scuppers located on the hullside. Each
scupper has a rubber flap to prevent water from entering the boat. Check this material occasionally to keep
them free of debris and in good working condition.

WINTERIZATION

Routine maintenance checks should be performed prior to each trip in accordance with Chapter 1, but
a broader analysis should be done before winterizing your catamaran and prior to the first trip of the sea-
son. If your local climate does not require winter storage, complete the following steps at least annually to
ensure the safe operation of your boat.
1. Do not leave loose items or personal affects onboard during storage. Remove all trash and debris
prior to cleaning the boat.
2. Before storage clean the boat thoroughly, including exterior surfaces, fishboxes, livewells, and
thru hull fittings. If possible leave lids open slightly to allow fresh air exchange. Remove the
garboard drains and store the boat with the bow up to allow drainage.
3. Inspect all electrical connections and the operation of pumps or other electrical devices. Perform
repairs if necessary. Coat electrical panels with an anti-corrosive spray, available from your
dealer.
4. Inspect the batteries and charge fully to prevent damage during storage. Disconnect the cables
and apply a coat of grease to the terminals to prohibit corrosion.
5. Inspect all plumbing components and connections to prevent leaks. Replace any damaged hoses.
Drain all lines and devices to prevent damage from freezing. Lubricate valves to maintain proper
operation. Use the manufacturers recommendations for portable and marine heads.
6. Inspect fuel system components and replace fuel/water separators. You can keep the system fuel
but do not overfill, and use a fuel additive to prevent condensation.
7. Lubricate hinges and coat all metal surfaces with Boeshield T-9™ or other metal protector.
Tighten down hardware if necessary.
8. Inspect caulking around hardware, windows, hatches, etc. to prevent water damage. Normal use
will break down sealants and can lead to costly repairs if not maintained.
9. Remove or cover all electrical devices to prevent damage from UV rays. The rays will cloud
electrical displays and make them hard to read.
10. Remove cushions and store indoors to prevent damage.
11. Winterize the engines and controls per manufacturers recommendations and inspect all connec-
tions, filters, and parts thoroughly. Replace parts as needed.
4-4