Rear Mounting - Blower Motor - Jenn-Air W10201609B Installation Instructions And Use And Care Manual

NOTE: Optional blower motor mounting position (opposite side).
The blower motor box assembly can also be moved to the
opposite side (rear) of the vent box.
A
A. Panel
B. Blower motor - rear mounting
1. Loosen the 2 hex/slotted head screws that attach the top
bracket that secures the motor to the vent box enough to
slide the bracket into the "Z" slots. This will move the bracket
away from the top mounting lip of the blower box and allow it
to tilt away from the vent box panel.
A
A. Bracket with "Z" slots
B. Hex/slotted head screws (2)

Rear Mounting - Blower Motor

B
B
B
2. Lift up the blower box from the bottom mounting channel.
A. Blower box
B. Bottom mounting channel
3. Disconnect the wire connector from the blower motor.
A
A. Blower motor
B. Wire connector
4. Remove panel from the opposite side of blower motor.
Loosen the 2 hex/slotted head screws that attach the top
bracket that secures the panel to the vent box enough to
slide the bracket into the "Z" slots. This will move the bracket
away from the top mounting lip of the panel and allow it to tilt
away from the vent box panel.
A
A. Bracket with "Z" slots
B. Hex/slotted head screws (2)
B
A
B
B
B
13