Jenn-Air W10201609B Installation Instructions And Use And Care Manual page 11

4. Place the bottom tab of the blower box into the bottom
mounting channel.
A. Blower box
B. Bottom mounting channel
5. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket. Slide bracket
into the "Z" slots and tighten the 2 hex/slotted head screws
to secure.
6. See "Complete Installation" section.
Rear Venting:
1. Remove the vent box. Loosen the 2 hex/slotted head screws
that attach the top bracket that secures the motor to the vent
box enough to slide the bracket into the "Z" slots. This will
move the bracket away from the top mounting lip of the
blower box and allow it to tilt away from the vent box panel.
A
A. Bracket with "Z" slots
B. Hex/slotted head screws (2)
B
A
B
B
2. Lift up the blower box from the bottom mounting channel and
set aside.
A. Blower box
B. Bottom mounting channel
3. Disconnect the wire connector from the blower motor.
A
A. Blower motor
B. Wire connector
4. Remove the 2 screws that mount the motor mounting bracket
to the vent box. Remove the blower motor and mounting
bracket assembly from the vent box.
A
A
A. Blower motor mounting bracket screws (2)
5. Remove the 4 screws from the small cover plate on the rear
of the vent chamber and set screws and cover plate aside.
B
A
B
11