Rsp-1 Remote; Changing The Battery - Emotiva RSP-1 User Manual

Professional stereo preamplifier/processor
Hide thumbs Also See for RSP-1:
Table of Contents

Advertisement

RSP-1 Remote

The RSP-1 remote control is a dedicated remote control that offers many discrete buttons for most of the
critical RSP-1 controls.
Power Button
Turns the RSP-1 on and off
Mute Button
Push to mute the RSP-1. The
MUTE LED on the front panel will
illuminate when this feature is
Source Selection Buttons
These buttons select the various
source inputs of the RSP-1
STEREO/MONO Button
Press to select stereo or mono
As many home entertainment enthusiasts choose, you may elect to program the RSP-1 remote into a
"learning" type remote that is the single (Master) control for all of your home entertainment components. In
doing so, you can choose to include or omit certain functions if you wish so you do not inadvertently enter
into those functions during normal use with the master remote. A master remote can also provide a unified
turn on/off resource for all of the components in the system through the use of a macro program sequence.

Changing the Battery

The RSP-1 remote contains a CR2032 battery that is pre-installed at the factory. If you should ever need to
replace this, simply remove 4 screws holding on the back cover, lift off the cover, and there you will see the
battery. Pay attention to polarity orientation when removing so that you position the new battery correctly.
Page 12
engaged.
Volume UP/DOWN
These buttons control the volume up
and volume down of the RSP-1. The front
panel volume knob will rotate when the
remote is used to control volume.
Source Direct Button
Push to bypass all of the preamp
functions of the RSP-1 including the
external processor loop and bass/treble
controls. The DIRECT LED will illuminate
when this feature is engaged.
External Processor Button
Push to switch to the External Processor
input/output. The current input selection
will pass through the processor loop.
The EXT PROC LED will illuminate when
this feature is engaged.
Tape Monitor Button
Push to enable recording from the
current input selected on RSP-1. The TAPE
LED will illuminate when this feature is
engaged.

Advertisement

Table of Contents
loading

Table of Contents