Connecting I/O Devices; Connection Of An External Signal Processor - Emotiva RSP-1 User Manual

Professional stereo preamplifier/processor

Hide thumbs Also See for RSP-1:

Table of Contents

Connecting I/O Devices

This connection diagram shows an external signal processor connected to the RSP-1 preamplifier via RCA

outputs and inputs. To engage the processor loop, select the EXT PROC button on the front panel or on the

remote control.

Inputs AND Outputs

To enable the preamplifier loop you must connect to the

inputs AND outputs on the RSP-1 labeled "EXT PROC" on

the rear panel. To engage the processor loop, select EXT

PROC from the RSP-1 front panel or the remote.

Page 18

Please note - the external processor loop is

unaffected by the Bass, Treble, and Balance

controls of the RSP-1. Use caution when

boosting any signal processor levels so you

can avoid unnecessary distortion.

Table of Contents