Connection Of A Recorder (Cassette, Dat, Hd, Etc.) - Emotiva RSP-1 User Manual

Connection of a Recorder (Cassette, DAT, HD, etc.)

This connection diagram shows an external recording device connected to the RSP-1 preamplifier via RCA
outputs and inputs. While this traditionally has been a cassette player or DAT player, this connection could
also be a hard drive based recording device so long as the input and output connections are analog RCA
audio connections.
To engage the recording device, first press TAPE from the front panel or remote and then it will allow you
to "monitor" the audio that the recording device will record. When you are ready to record, engage the
recording device.
Inputs AND Outputs
To enable the tape monitor loop you must connect to
the inputs AND outputs on the RSP-1 labeled "TAPE" on
the rear panel. To engage the tape monitor loop, select
TAPE from the RSP-1 front panel or the remote.
Please note - the tape loop outputs are
unaffected by the Bass, Treble, and Balance
controls of the RSP-1. These outputs are
also unaffected by any external signal
processing.
Page 19