Lo Flame Adjustment; To Adjust Grill Burner Air Shutters And Surface Burner Air Shutters; To Adjust The Lo Setting - Jenn-Air SVD48600 Use And Care Manual

To adjust grill burner air shutters and surface burner air shutters
(some models)
The left hand air shuttercontrolsthe rear half of the grill burner, or the rear surface
burner.The righthandshuttercontrolsthe fronthalfofthe grillburneror thefrontsurface
burner.
Slide air shutter backward or forward to
increase ordecreasethesizeoftheairopening.
__NGRILL
BURNER AIR SHUTFER
Air shutters fit snugly on the burner, so a __E_'_ D_
screwdriverblade may be requiredto make
this adjustment, Observe change in flame
appearance as the air shutter is moved. IVERBLADE
Adjustment is satisfactorywhen a clearly INSLOTAND'rWISTWITH
SLIGHT PRESSURE TO ALLOW
defined, even blue flame results at the Hi AIRSHUTTERTOSLIDEEASILY.
flame setting. The snugfit of the air shutter
assures it will remainpositionedcorrectly.
On any burner,closingthe air shuttertoo far willcause the flame to become soft and
yellowtipped.Openingthe air shuttertoo wide will cause the flame to blowaway from
the burnerports, Proper adjustmentwill producea sharp, clearly defined even, blue
flame.
This appliancehas been shipped from the factory with Lo and Med flame settings
adjustedfor usewith naturalgas and average installations. T here is a wide variety of
conditions causedbyaltitudeand gas mixturescontrolled by utilitycompanieswhichwill
vary and affectthe gas flame and performance.Adjustments shouldbe made at time
of installation. If conditionschange, follow the procedures outlined below to adjust the
Lo setting.
To adjust the Lo setting
1. Light burnerand set controlknob for lowflame.
2. Remove control knob from valve stem.
CAUTION: Never use a metal blade to pry
knob off. If knob cannot be easily removed
CLCCk'W/,S_
tuck the folds of a cloth dishtowelunder the TOREOUCE
knob skirt and pull the towel forward with _ _lr_
steady, even pressure.
3. Insert a slender, thin-blade screwdriver into
the recessat centerof valve stemand engage COU_RCLOC.W,SE
blade with slot in adjustingscrew. TO _NCR_SE F_ME
SIZE
4. Turn center stem adjustingscrew slightlyto _
set flame size.Note: Turn clockwise to reduce
or counterclockwise t o increase flame size.
5. Replacecontrolknob when adjustmentis completed.
Proper adjustmentwill producea stable,steady blue flame of minimumsize. The final
adjustmentshould be checked by turning knobfrom Hi to Lo several times without
extinguishing the flame. This adjustment,at the Lo setting,will automaticallyprovide
the proper flame size at Meal setting. 13