The surface burnermoduleconsistsof twosurfaceburnergrates, an aerationtray and
a burnerassembly.
To Install Burner Module
1. Be sure controlknobsare turned Off.
2. If the grill burnerand grill grates are in place, remove before instarling a surface
burnermodule.Clean burner basinof any grease accumulation. ( See page 21 for
cleaning recommendations.)
3. Positiontheburnerassemblywiththemixertubeopeningstowardtheorifices. Slide
the burnerassemblytowardthe orificesuntilopeningfor igniterisover the igniter.
Lowerintoplace untilside openings are restingon the burnersupportsand igniter
is centeredbetweenthe two flash tubes.
4. Installthe aerationtray byinserting the prongat the end of the pan intothe opening
in the end of the burnerbasin. Lowerthe oppositeend intothe rangetop.
Note: Beforefirst use, read the Surface BurnerOrates Care instructions foundon
page 46.
To Remove Burner Module
1. Control knobsshouldbe in the Off positionand the rangetopshouldbe cool.
2. Removethe aerationtray by liftingup the frontend on the rightside (backend on
the left side) untilthe top clearsthe openingof the rangetopby about5 inches.
3. Holdaerationtraybythesidesandslideawayto removethe prongfrom theopening
and clear the surface burners.
4. Liftup on the sidesof the surface burnerassemblybracket about2 inches. Slide
away from the orifices.
NOTE: Optionalsurfaceburnerassembly,ModelAG202, can replacethe grillburner
assembly. ModelAG202 airshuttershavebeen adjustedfor compatibility on
the left side.
NOTE: Do not disassemblethe surface burnerassembly.
16