Example Of Copy Function; Verifying Parameters (Vfy) - Omron SYSDRIVE 3G3MV Setup Manual

Preparing for Operation and Monitoring

Example of Copy Function

H Verifying Parameters (vFy)
• The Parameter Copy and Verify Function (n176) can be set to "vFy" to compare the parameter settings
in the Digital Operator with those in the Inverter.
D Verifying Parameters
Key Indicator
---
(After
comparison is
finished.)
or
Note 1. If the STOP/RESET Key is pressed when a non-matching parameter number or setting is dis-
played, verification will be canceled at that point and "End" will be displayed. The parameter
number display will then return if the Mode Key or Enter Key is pressed.
Note 2. "vAE" (capacity error) will be displayed if verification is attempted between Inverters with dif-
ferent capacities. Press the Enter Key to continue the verification operation. Press the STOP/
RESET Key to cancel the verification operation.
2-12
Display
(Display after the power supply is turned ON.)
Press the Mode Key until the PRGM indicator lights.
Confirm that n001 is displayed on the data display.
Press the Increment/Decrement Key until "n176" is
displayed.
Press the Enter Key.
"rdy" will be displayed.
Press the Increment Key until "vFy" is displayed
Press the Enter Key. The parameter settings will be
compared and the display will flash.
The parameter number of any parameter that has different
settings will be displayed.
Press the Enter Key.
The setting of the parameter in the Inverter will be displayed
(flashing) first.
Press the Enter Key again.
The setting of the parameter in the Digital Operator will be
displayed (flashing) next.
Press the Increment Key.
The comparison will be continued.
"End" will be displayed when the comparison has been
finished.
Press the Mode Key or Enter Key.
The display of the parameter number will return.
Chapter 2
Description