Honeywell Fusion IV User Manual page 7

Digital recording and transmission system
Table of Contents

Advertisement

EN 50130-4:1996 Notice
1.
Uninterrupted Power supply (UPS)
2.
Maximum lengths of wiring connected to the sensor inputs and control outputs are 30 meters.
OPTICAL AND ACOUSTICAL STATEMENTS
VISIBLE LED STATEMENT
The LEDs on this DVR are classified as "Class 1 LED Product" in accordance with EN 60825-1.
LASER SAFETY STATEMENT FOR A CLASS 1 LASER PRODUCT
This DVD-ROM Storage device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may
cause harmful interference. If this equipment does cause harmful interference to radio or television reception, the
user can attempt to correct this by following one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
Consult the dealer or an experienced radio TV technician for help.
The mass storage system does not product hazardous laser radiation. Because laser light emitted inside the
mass storage system is completely confined within the protective housings and external covers, the laser beam
cannot escape from the machine during any phase of user operation.
Check each DVD for cracks before using it. If there are cracks on the surface, especially on the border of
the center hole, do not use it in the DVD-ROM drive. Using such DVDs can cause irreparable damage to
the DVD-ROM drive.
Do not leave DVDs in direct sunlight or hot, humid locations.
Always remove DVDs from the drive after use.
To protect DVDs from scratches, never touch the DVD face or place the DVD face down on a hard
surface.
Do not affix highly adhesive stickers to a DVD.
VISIBLE LED STATEMENT
Lpa < 70 dB operator position, normal operation, per ISO 7779.
________________________________________________________________________________________________________
Document 800-05305 Rev A
11/09
Caution Due to the extremely fast rotation speed of the DVD-ROM drive spindle motor
(9000 ~ 12000 rpm), the drive's performance could be affected by using
substandard discs. These substandard discs may be damaged, or damage
the DVD-ROM drive.
Fusion IV DVR User Guide
7

Advertisement

Table of Contents
loading

Table of Contents