Setting Up The Server To Accept Incoming Communications - Honeywell Fusion IV User Manual

Setting up the Server to Accept Incoming Communications

________________________________________________________________________________________________________
142
In order to access the DVR remotely, the DVR Server must be setup to allow remote
connections.
Disable Remote Enables/Disables acceptance of remote connections by the DVR
Control server.
Time Out Value Specifies a value (in seconds) to wait for a signal from the Fusion
Remote Client. If a signal is not received by that time, the
connection is dropped.
Center Port Used by the DVR to transfer the connection data.
Image Port Used by the DVR to transfer the image data.
Search Port Used by the DVR to transfer the search data
1. Enter Setup on the DVR.
2. Click the Network tab.
3. Clear the Disable Remote Control check box.
If a Firewall is used, it may be necessary to adjust the port settings on both
Note
the DVR and the Firewall. Contact the Network Administrator for more
information.
4. Click OK.
5. Make sure a User account is created. Without a user account, the Administrator
account must be used.
The DVR server is now ready to receive incoming connections.