Led Indicators - D-Link DES-3526 Manual

LED Indicators

The Switch supports LED indicators for Power, Console, RPS (DES-3526 only) and Port LEDs. The
following shows the LED indicators for the DES-3526 along with an explanation of each indicator.
LEDs for the
LED
Power
Console
RPS (DES-3526 only)
Port LEDs
100M/10M
Gigabit Ports
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Figure 1- 3. LED Indicators on DES-3526
Description
This LED will light green after the Switch is powered on to indicate the ready state of
the device. The indicator is dark when the Switch is powered off.
This LED should blink during the Power-On Self Test (POST). When the POST is fin-
ished, the LED goes dark. This indicator is lit sold green when the Switch is being
logged into via out-of-band/local console management through the RS-232 console
port in the back of the Switch using a straight-through serial cable.
This LED will be lit when the redundant power supply is present and in use. Otherwise
it will remain dark.
One row of LEDs for each port is located above the ports on the front panel. The first
LED is for the top port and the second one is for the bottom ports. These port LEDs
will light two different colors for 10M and 100M.
Amber - For speeds of 10 Mbps. A solid light denotes activity on the port
•
while a blinking light indicates a valid link.
Green - For speeds of 100 Mbps. A solid light denotes activity on the port
•
while a blinking light indicates a valid link.
These LEDs will light steady green to indicate that the port is transferring data at
100Mbps.
The Switch's two Mini GBIC ports have their own corresponding LEDs:
Speed - This LED will light solid green when the port is transferring at a rate of
1000Mbps. When dark, the port is transferring at 10/100Mbps.
Link/Act - This LED will light solid green when there is a valid link. A blinking LED
indicates current activity on the port. A dark LED indicates no activity on the port.
4