D-Link DES-3526 Manual page 160

To add a new entry to the Switch's SNMP Group Table, click the Add button in the upper left-hand
corner of the SNMP Group Table window. This will open the SNMP Group Table Configuration
window, as shown below.
The following parameters can set:
Parameter
Group Name
Read View Name
Write View Name
Notify View Name
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Figure 7- 32. SNMP Group Table Configuration window
Figure 7- 33. SNMP Group Table Configuration window
Description
Type an alphanumeric string of up to 32 characters. This is used to identify the new
SNMP group of SNMP users.
This name is used to specify the SNMP group created can request SNMP mes-
sages.
Specify a SNMP group name for users that are allowed SNMP write privileges to
the Switch's SNMP agent.
Specify a SNMP group name for users that can receive SNMP trap messages
generated by the Switch's SNMP agent.
147