D-Link DES-3526 Manual page 103

Offset
Click Apply to implement changes made.
To establish the rule for a previously created Access Profile:
In the Configuration folder, click the Access Profile Table link opening the Access Profile Table
window. Under the heading Access Rule, clicking Modify, will open the following window.
To create a new rule set for an access profile click the Add button. A new window is displayed. To
remove a previously created rule, click the corresponding X button.
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
This field will instruct the Switch to mask the packet header beginning with the offset
value specified:
value (0-15) - Enter a value in hex form to mask the packet from the
•
beginning of the packet to the 16th byte.
value (16-31) – Enter a value in hex form to mask the packet from byte 16 to
•
byte 31.
value (32-47) – Enter a value in hex form to mask the packet from byte 32 to
•
byte 47.
value (48-63) – Enter a value in hex form to mask the packet from byte 48 to
•
byte 63.
value (64-79) – Enter a value in hex form to mask the packet from byte 64 to
•
byte 79.
Figure 6- 57. Access Rule Table window
90