D-Link DES-3526 Manual page 99

The following parameters can be set, for the Ethernet type:
Parameter
Profile ID (1-255)
Type
VLAN
Source Mac
Destination Mac
802.1p
Ethernet type
The window shown below is the Access Profile Configuration window for IP.
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Figure 6- 54. Access Profile Configuration window (Ethernet)
Description
Type in a unique identifier number for this profile set. The number is used to set the
relative priority for the profile. Priority is set relative to other profiles where the lowest
profile ID has the highest priority. If a conflict occurs among configured access rules,
the profile ID establishes relative priority of the rules. The value can be set from 1 to
255 however there is a limit to the total number of profiles that can be created.
Select profile based on Ethernet (MAC Address), IP address or packet content mask.
This will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
•
packet header.
Select IP to instruct the Switch to examine the IP address in each frame's
•
header.
Select Packet Content Mask to specify a mask to hide the content of the
•
packet header.
Selecting this option instructs the Switch to examine the VLAN identifier of each
packet header and use this as the full or partial criterion for forwarding.
Source MAC Mask - Enter a MAC address mask for the source MAC address.
Destination MAC Mask - Enter a MAC address mask for the destination MAC
address.
Selecting this option instructs the Switch to examine the 802.1p priority value of each
packet header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the Ethernet type value in each
frame's header.
86