Table of Contents
Advertisement
8 0 m m (3.15 anl
(PAGE 40)
5-2. REAR WHEEL
A. Removal (XS650SF only)
1.
Support the machine on the center stand.
2. Disconnect the drive chain. Using the
drive chain cutter (special tool).
NOTE: __
The chain joint should be replaced each time
the chain is cut.
Remove the axle nut cotter pin and the
3.
axle nut.
While supporting the brake caliper, pull
4.
out the rear axle.
5.
Remove the rear wheel assembly.
E. Installing rear wheel (XS650SF only)
When installing rear wheel, reverse removal
procedure taking care of following points:
1.
Lightly grease lip of rear wheel oil seals.
2. Make sure the brake pads are installed
properly and that there is a sufficient
gap to install the rear disc.
3. Install the wheel assembly and the axle.
Always use a new cotter pin on the axle
nut.
Axle nut torque:
15.0 m-kg
(108.5 ft-lb)
4. Connect the drive chain.
5. Adjust the drive chain.
(PAGE 40 - 44)
5-3. BRAKES
Except for the following, the same procedure
as for the XS650E front brake can be perform-
ed for the disassembly, inspection,and assem-
bly of the XS650SF (front and rear brake)
and the XS650-2F (front brake).
D. Brake inspection and repair
Specifications should changed as follows:
Wear limit:
6.0 mm (0.24 in)
(PAGE 44)
5-4. WHEELS, TIRES, TUBE (XS650SF -
Tubeless tire model)
Refer to "Tubeless tire and Aluminium Wheel
Manual" for tubeless tire and wheel service.
- 143-
1 1 . 0 m m ( 0 . 4 3 In)
6 : W e a r l i m i t
6.0 mm 10.24 1n1
Advertisement
Table of Contents
