Yamaha XS650SE Shop Manual page 105

Part to be tightened
Brake disc and hub
Caliper and support bracket
pad
Caliper and
Caliper and bleed screw
Front caliper and front fork
Master cylinder and cylinder bracket
Pivot shaft
Tension bar and brake caliper (plate)
Tension bar and rear arm
Rear shock absorber
Rear shock absorber
Rear arm and rear arm end
Front fender
Neutral switch
General Torque Specifications
This chart specifies torque for standard
fasteners with standard I.S.O. pitch threads.
Torque specifications for special components
or assemblies are included in the applicable
sections this book.
Thread dia. and pan name
B mm bolt
8 mm bolt
5 mm bolt
10 mm bolt
14 mm nut
16 mm nut
B mm nut
10 mm bolt
10 mm bolt
tighten multi-fastener assemblies in a criss-
cross fashion, in progressive stages, until full
torque is reached. Unless otherwise specified,
torque specifications call for clean, dry
threads.
temperature.
To avoid warpage,
1.8 m-kg 113.0 ft.lbi
0.3 m-kg I 2.2
0.6 m-kg
3.5 m-kg (25.5 ft-lb)
0.6 m-kg
bolt
6.5 m-kg (47.0 ft-lb)
1.8 m-kg (13.0 ft-lb)
3.2 m-kg (23.0 R-lb1
3.0 m-kg (21.5 ft-lb1
1.0 m~kg
b o l t
Components should be at room
4.5 ft-lb)
4.5 ft-lb)
7.2 ti-lb1