Yamaha XS650SE Shop Manual page 144

Remarks
Throttle grip/
Housino Apply lightly
Hydraulic brake
Use new fluid only
fluid reserve
Clean/Replace as
Oil filter element
required
Drain completely - Yamaha Fork Oil
Front forks
Check specifications 20 wt.
Inspect thoroughly
Steering bearings Pack moderately
Yearly or . . .
Speedometer gear Inspect thoroughly
Pack moderately
Rear arm pivot
Apply grease fully
shafts
Do not over-pack
Wheel bearings
Yearly or . . .
Point cam lubri-
cation wicks
NOTE :
Brake fluid replacement:
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally check the
brake fluid level and add the fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years.
3. Replace the brake hoses every four years, or if cracked or damaged.
(PAGE 7,10 13)
24. CHASSIS
Fuel petcock cleaning
A.
1. Open the seat and remove the fuel tank
securing bolt.
2. Turn the petcock lever to the "ON" or
"RES" position. Raise the fuel tank to
remove the fuel pipe.
400
(250) (500) (1,000) (2.000) (1,000) (2.000) (4.000)
Lithium basegrease
DOT No. 3
check
0
Medium-weight
wheel bearing grease
Lithium base grease
Medium-weight
wheel bearing grease
Medium-weight
wheel bearing grease
Light-weight
3. Remove the drain bolt and clean with
solvent. If gasket is damaged, replace.
Drain bolt
E. Rear
The rear brake pedal should be so adjusted
that it has a free play of 13 - 15 mm (0.51
to when the brake begins to be effected.
1. Loosen the adjuster lock nut (for pedal
height).
2. By turning the adjuster bolt clockwise or
counterclockwise, adjust the brake pedal
initial
800 1,600
3,200 1,600
0
check check
check check
0
0
0 0 0
brake
Unit: km (mi)
Thereafter every
3,200
6,400
0
0
0
2,800
2,800
2,800
2,800
0