Fortinet FortiSwitch-5003B System Manual page 25

Hardware installation
FortiSwitch-5003B System Guide
01-400-134822-20120216
http://docs.fortinet.com/
6 Keep the handles in this position until the IPM LED stops flashing and becomes solid
blue.
Waiting for the IPM LED to change to solid blue makes sure that the board software
shutdowns completely before disconnecting it from backplane power.
7 Open the handles to their fully open positions.
To avoid damaging the lock, make sure you squeeze the handles fully to unlock them
before opening. The handles should pop easily out of the board front panel.
Opening the handles turns off the microswitch, turns off all LEDs, and ejects the board
from the chassis slot. You need to use moderate pressure on the handles to eject the
board.
Alignment Pin
Handle
Open
Lock
8 Pull the board about half way out.
9 Turn both handles to their fully-closed positions.
When the handles are fully-closed they lock into place.
Alignment Pin
Close
Handle
10 Carefully slide the board completely out of the slot.
11 Re-attach the protective metal frame if you are going ship the FortiSwitch-5003B
board or store it outside of a chassis.
Shutting down and removing a FortiSwitch-5003B board
Alignment Pin
Handle
Alignment Pin
Handle
Fully Closed
and Locked
25