Fortiswitch-5003B Mounting Components - Fortinet FortiSwitch-5003B System Manual

FortiSwitch-5003B mounting components

FortiSwitch-5003B mounting components
20
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
FortiSwitch-5003B boards must be protected from static discharge and physical shock.
Only handle or work with FortiSwitch-5003B boards at a static-free workstation. Always
wear a grounded electrostatic discharge (ESD) preventive wrist strap when handling
FortiSwitch-5003B boards.
1 Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap
terminal.
2 If you have installed the FortiSwitch-5003B board in a chassis, remove it.
For removal instructions, see
board" on page 24.
3 Use Figure 5 on page 18
4 If required, change SW2 to the correct setting.
5 Insert the FortiSwitch-5003B board into a chassis and verify that the board starts up
and operates correctly.
For inserting instructions, see
To install a FortiSwitch-5003B board you slide the board into a hub/switch slot in the front
of an ATCA chassis (usually slot 1 or 2) and then use the mounting components to lock
the board into place in the slot. When locked into place and positioned correctly the
board front panel is flush with the chassis front panel. The board is also connected to the
chassis backplane.
FortiSwitch-5003B boards are horizontal when inserted into a FortiGate-5050 chassis
and vertical when inserted into a FortiGate-5140 chassis. The inserting and removing
procedures are the same in either case. For clarity the descriptions in this document
refer to the left (top) and right (bottom) mounting components.
To position the board correctly you must use the mounting components shown in
Figure 8 for the right (bottom) of the FortiSwitch-5003B front panel. The mounting
components on the left (top) of the front panel are the same but reversed. The
FortiSwitch-5003B mounting components align the board in the chassis slot and are
used to insert and eject the board from the slot.
"Shutting down and removing a FortiSwitch-5003B
to locate SW2 on the FortiSwitch-5003B board.
"Inserting a FortiSwitch-5003B board" on page
Hardware installation
21.
FortiSwitch-5003B System Guide
01-400-134822-20120216
http://docs.fortinet.com/