Fortinet FortiSwitch-5003B System Manual page 23

Hardware installation
FortiSwitch-5003B System Guide
01-400-134822-20120216
http://docs.fortinet.com/
6 Carefully guide the board into the chassis using the rails in the slot.
Insert the board by applying moderate force to the front faceplate (not the handles) to
slide the board into the slot. The board should glide smoothly into the chassis slot. If
you encounter any resistance while sliding the board in, the board could be aligned
incorrectly. Pull the board back out and try inserting it again.
7 Slide the board in until the alignment pins are inserted half way into their sockets in
the chassis.
8 Turn both handles to their fully-closed positions.
The handles should hook into the sides of the chassis slot. Closing the handles draws
the FortiSwitch-5003B board into place in the chassis slot and into full contact with
the chassis backplane. The FortiSwitch-5003B front panel should be in contact with
the chassis front panel. When the handles are fully-closed they lock into place.
As the right (bottom) handle closes the microswitch is turned on, supplying power to
the board. If the chassis is powered on the HS LED starts flashing blue. If the board is
aligned correctly, inserted all the way into the slot, and the right (bottom) handle is
properly closed the HS LED flashes blue for a few seconds. At the same time the ACT
and HTY LEDs turn green. After a few seconds the HS LED goes out and the
FortiSwitch-5003B firmware starts up. If the board is operating correctly, the front
panel LEDs are lit as described in
Table 12: FortiSwitch-5003B normal operating LEDs
LED State
OOS Off
Power Green
Status Off
Off (Or flashing green when the system accesses the
ACC
FortiSwitch-5003B flash disk.)
IPM Off
If the board has not been inserted properly the HS LED changes to solid blue and all
other LEDS turn off. If this occurs, open the handles, slide the board part way out, and
repeat the insertion process.
9 Once the board is inserted correctly, fully tighten the retention screws to lock the
FortiSwitch-5003B board into position in the chassis slot.
Retention
Tighten
Table 12.
Screw
Inserting a FortiSwitch-5003B board
23