Fortinet FortiSwitch-5003B System Manual page 22

Inserting a FortiSwitch-5003B board
22
To insert a FortiSwitch-5003B board into a chassis slot
Do not carry the FortiSwitch-5003B board by holding the handles or retention screws.
When inserting or removing the FortiSwitch-5003B board from a chassis slot, handle the
board by the front panel. The handles are not designed for carrying the board. If the
handles become bent or damaged the FortiSwitch-5003B board may not align correctly
in the chassis slot.
To complete this procedure, you need:
• A FortiSwitch-5003B board
• An ATCA chassis with an empty hub/switch slot
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
FortiSwitch-5003B boards must be protected from static discharge and physical shock.
Only handle or work with FortiSwitch-5003B boards at a static-free workstation. Always
wear a grounded electrostatic discharge (ESD) preventive wrist strap when handling
FortiSwitch-5003B boards.
1 Attach the ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2 If required, remove the protective metal frame that the FortiSwitch-5003B board has
been shipped in.
3 Insert the FortiSwitch-5003B board into the empty hub/switch slot in the chassis.
4 Unlock the handles by squeezing the handle locks.
Unlock
Handle
5 Open the handles to their fully open positions.
To avoid damaging the lock, make sure you squeeze the handles fully to unlock them
before opening. The handles should pop easily out of the board front panel.
Alignment Pin
Handle
Open
Lock
Hardware installation
Alignment Pin
Handle
FortiSwitch-5003B System Guide
01-400-134822-20120216
http://docs.fortinet.com/