AT&T SB67010 Gateway, SB67030 Deskset System Administrator's Guide
To install the Gateway: (Continued)
2. Plug the AC plug into an electrical outlet not controlled by a wall switch and the DC plug into the DC5.1V jack, as shown
in Figure 23. Wait up to one minute until the screen lights up.
CAUTION: To help prevent the loss of system data during power outages, plug the AC power plug into an
3. Plug an RJ-45 Ethernet cable into the RJ-45 Ethernet port marked LAN. Plug the other end of the RJ-45 Ethernet cable
into your office LAN.
CAUTION: Some DHCP servers have default settings that limit the number of IP addresses. Each Deskset,
Screen
Installation
Uninterruptible Power Supply (UPS).
Gateway, and personal computer needs an IP address. You should log in to your DHCP server to
confirm that the IP range is sufficient to accommodate all of your devices.
LINE 1 through LINE 4
Figure 23. Gateway Installation
BYPASS
LAN
24
AC Plug
DC 5.1V
DC Plug