AT&T SB67030 System Administrator Manual page 23

AT&T SB67010 Gateway, SB67030 Deskset System Administrator's Guide
To install the Gateway:
1. To connect the Gateway to Earth ground:
a. Loosen the screw retaining the silver grounding terminal on the back of the Gateway, as identified in Figure 22.
b. Insert the spade/fork end of the grounding cable under the grounding terminal.
c. Tighten the screw.
d. Connect the alligator clip end of the grounding cable to the building ground point, usually located at the electrical
breaker box.
WARNING: If you are unsure about the location of the building ground point or how to ground
Installation
the Gateway, contact the facilities manager.
Grounding Terminal (Back Panel)
Figure 22. Gateway Grounding
23