Advertisement
5: Not set.
6: Not set.
7: Not set.
8: Not set.
OK
Other configuration commands
LE
Clear all settings for logging
L[X]1
(X represents analog or digital input. X[1...9, A, B, C])
Enable logging of input X
L[X]0
(X represents analog or digital input. X[1...9, A, B, C])
Disable logging of input X
LMC
Sets logging memory to circulate. If the memory is full, it will overwrite the oldest
logs.
LMS
Sets logging memory to stop if the memory is full.
D[X]
(X [0...9])
Set delay for x seconds
Q
Quit service mode
In service mode you can go to SD card setup by pressing S command.
In SD Card Setup there are following commands:
?
Checks for card format. If wrong, it will format the card and prepare for data logging.
If the card format is ok and there are logged files it will display all files on the card.
?
Wait a minute. Checking the SD card.
LOGBOX SD SD card format OK.
ELOG0000.TXT
51 2007-06-16 13:21:06
ELOG0001.TXT
512 2007-06-16 13:22:00
ELOG0002.TXT
4886 2007-06-16 13:30:00
ELOG0003.TXT
7922 2007-06-16 13:40:00
ELOG0004.TXT
7922 2007-06-16 13:50:00
ELOG0005.TXT
7922 2007-06-16 14:00:00
ELOG0006.TXT
7922 2007-06-16 14:10:00
...
ELOG0278.TXT 773632 2007-09-11 21:22:04
SD card size:
Next File: ELOG0279.TXT at
L
This command will print all the files on the card.
127139840 Bytes
96894976
46
Advertisement
