Advertisement
Fig.4 Connecting the battery, which is fixed on the top cover
Last step is to connect the (supplied) serial cable RS232 with the computer. The
LOGBOX SD software can be used to setup the logger and related sensors. Or setup
your communication software on your computer (e.i. HyperTerminal) for standard
speed 115200bps, 8 data bits, 1 stop bit, parity none and handshaking none. Then
you will see measured data from LOGBOX SD.
Fig.5 Serial cable connection
LOGBOX SD is ready to operate. Depending on saved configuration LOGBOX SD
performs measurement, logging and printout of measured data on serial line, which
can be seen on the computer.
Setting up configuration is described in next
chapters.
14
Advertisement
