JBL SYNTHESIS SDP-40HD User Manual page 74

Setup
SETUP
MAIN MENU
INPUTS
MODE ADJUST
SPEAKERS
AUDIO CONTROLS
REAR PANEL CONFIG
SETUP
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
REAR L/R
FULL, FULL + SUB, 30Hz to 120Hz, THX 80Hz, NONE
SETUP SPEAKERS CUSTOM SETUP
Assigns a crossover point for the Main Zone audio output connector
labeled REAR L/R when a custom speaker setup is selected. Opens
the REAR L/R SPEAKERS menu to select a crossover point for the
REAR L/R output connectors.
• Select FULL to send a full-range signal to the rear speakers.
Otherwise, select the crossover point closest to the low
frequency rating of the rear speakers.
• Select FULL + SUB to send a full-range signal to the rear
speakers and duplicate bass frequencies to the SUB L/R
outputs. (The set crossover point of the SUB XOVER parameter
determines the upper range of duplicate bass.) Selecting the
FULL + SUB option can result in excessive bass.
• Select NONE when the speaker setup does not include rear speakers.
The SDP-40HD then redirects rear channel signals to the Side L/R
output connectors. If the SIDE L/R parameter is also set to NONE,
surround channel signals are sent to the Front L/R output connectors.
3-34
CUSTOM SETUP SPEAKER SETUP
SPEAKER SETUP
CUSTOM SETUP 40 Hz
CUSTOM SETUP
SYNTHESIS 7 CH SETUP 60 Hz
SPEAKER DISTANCES 60 Hz
SPEAKER DISTANCES
LEVELS CALIBRATION 60 Hz
LEVELS CALIBRATION
40 Hz
R SR RR
OFF
80Hz
80Hz 80Hz
N/A
C
APART
80Hz
M
L SL RL
SUB
80Hz 80Hz
80Hz 80Hz
REAR L/R
SYNTHESIS 7 CH SETUP
SYNTHESIS 7CH SETUP
FRONT L/R
!CAUTION!
CENTER
PRESSING THE
SIDE L/R
BUTTON WILL
REAR L/R
AUTOMATICALLY CHANGE
SUB L/R
THE OUTPUTS TO A
SUB XOVER
SYNTHESIS 7CH
LFE
SPEAKER
ULTRA2 SUB
CONFIGURATION
BGC
ASA
REAR SPEAKERS
80Hz
NONE
SETUP SPEAKERS SYNTHESIS 7CH
When a SYNTHESIS 7CH speaker setup is selected, the REAR L/R
parameter opens the SYNTHESIS 7CH REAR SPEAKERS menu shown
above, to activate and deactivate the REAR L/R output connectors.
• Select 80Hz to activate and configure the Rear L/R output
connectors for a 7.1-channel THX speaker setup.
• Select NONE to deactivate the Rear L/R output connectors,
configuring the Main Zone audio output connectors for a
5.1-channel THX speaker setup.
Note:
When the REAR L/R parameter is set to NONE, Dolby Digital Surround
EX, THX Ultra2, THX Surround EX, PLIIx modes, DTS(-ES) decoding, and
the ASA parameter are not available.
80Hz
80Hz
80Hz
80Hz
MONO
80Hz
OFF
OFF
N/A
APART
REAR L/R
JBL