Restoring Factory-Default Settings - JBL SYNTHESIS SDP-40HD User Manual

SDP-40HD

RESTORING FACTORY-DEFAULT SETTINGS

When factory-default settings are restored, all parameters and
v a l u e s t h a t t h e o w n e r h a s d e f i n e d a re r e s t o re d t o t h e ir
factory-default settings. Before restoring factory-default settings,
you should record all of your current settings.
FACTORY SETTINGS
EXIT
RESTORE DEFAULTS
To restore factory-default settings:
1. Select one of the following options to record user defined settings:
• Use the Configuration Tool to download current SDP-40HD
settings to a personal computer (PC). The configuration
tool is available at www.jblsynthesis.com
• Record the settings you have defined on the installation
worksheet that begins on page A-19.
2. If the SDP-40HD is not in standby mode, press the Standby
Button.
3. When standby mode is activated, press the Standby Button
again, then quickly press and hold the Mute button until the
FACTORY SETTINGS menu shown above opens on the
on-screen and front panel displays.
Note:
The Mute button must be pressed within 2 seconds of deactivating
standby mode. Otherwise, the "MUTE ON" message will appear on
the on-screen and front panel displays. If this occurs, too much time
has passed. Press the Standby button and begin again at step 3.
FACTORY SETTINGS
HAVE BEEN RESTORED
PRESS ANY KEY
TO RESTART
Troubleshooting & Maintenance
4. Press the remote control
RESTORE DEFAULTS, then press the
the FACTORY SETTINGS menu without restoring factory default
settings, highlight EXIT, then press the
The FACTORY SETTINGS message appears on the front panel
and on-screen displays. When this message appears, press a
front panel or remote control button to restart the SDP-40HD.
or arrow button to highlight
arrow button. (To close
arrow button.)
6-5