Configuring Proxy Arp - Cisco 9971 Deployment Manual

To view the EAP configuration on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter the
following command.
(Cisco Controller) >show advanced eap
EAP-Identity-Request Timeout (seconds)........... 30
EAP-Identity-Request Max Retries................. 2
EAP Key-Index for Dynamic WEP.................... 0
EAP Max-Login Ignore Identity Response........... enable
EAP-Request Timeout (seconds)....................
EAP-Request Max Retries.......................... 2
EAPOL-Key Timeout (milliseconds)......................
EAPOL-Key Max Retries............................ 2
To change the EAP-Request Timeout on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter
the following command.
(Cisco Controller) >config advanced eap request-timeout 30
As of 6.0.182.0 release, the EAPOL-Key Timeout is configurable in milliseconds, where in previous releases it was only
allowed to be configured in seconds.
It is recommended to set the EAPOL_Key timeout to 200 milliseconds.
The EAPOL-Key Timeout should not exceed 1 second (1000 milliseconds).

Configuring Proxy ARP

To advertise the proxy ARP information element, ensure that Aironet extensions are enabled.
As of the 5.1.151.0 release, proxy ARP is always enabled and non-configurable.
For autonomous access points, enter "dot11 arp-cache optional".
Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide
30
1000
58