Controller Settings - Cisco 9971 Deployment Manual

dot11 ssid voice
vlan 21
authentication open eap
authentication network-eap
authentication key-management wpa cckm
admit-traffic
If the autonomous access point is registered to a WDS (Wireless Domain Services) server, ensure both leap and eap types of
authentication are enabled in the WDS configuration.
wlccp authentication-server infrastructure method_Infrastructure
wlccp authentication-server client mac method_Clients
wlccp authentication-server client
wlccp authentication-server client
wlccp wds priority 255 interface BVI1

Controller Settings

In releases prior to 6.0, Aggressive Load Balancing was configured in the General Controller settings.
In 6.0 and later, this is referred to as Client Load Balancing and is configurable under the WLAN configuration (SSID
settings).
If using layer 3 mobility, then symmetric tunneling should be enabled .
In the recent versions, Symmetric Mobility Tunneling is enabled by default and non-configurable.
Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide
eap_methods
eap_methods
eap method_Clients
leap method_Clients
46