Cisco 9971 Deployment Manual page 39

PC Port
USB1 (Back USB Port)
USB2 (Side USB Port)
Enable/Disable USB Classes
Bluetooth
Wifi
Bluetooth Profiles
Settings Access
Gratuitous ARP
PC Voice VLAN Access
Web Access
Days Display Not Active
Display On Time
Display On Duration
Display Idle Timeout
Span to PC Port
Logging Display
Load Server
Recording Tone
Recording Tone Local Volume
Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide
Indicates whether the PC port is enabled or disabled.
Default is enabled.
Indicates whether the back USB port is enabled or disabled.
Indicates whether the side USB port is enabled or disabled.
Indicates which USB classes are enabled or disabled.
Indicates whether Bluetooth is enabled or disabled.
Indicates whether WLAN is enabled or disabled.
Indicates which Bluetooth profiles are enabled or disabled.
Settings Access can be used to limit user access to certain menus.
Determines whether the phone will learn MAC addresses from Gratuitous ARP
responses or not.
Indicates whether the phone will allow a device attached to the PC port to access
the Voice VLAN or not.
Not applicable when in WLAN mode.
This parameter indicates whether the phone will accept connections from a web
browser or another HTTP client.
This field allows the user to specifiy the days that the backlight is to remain off
by default. To turn off the backlight for multiple days, hold down the control
key while selecting the days. Saturday and Sunday is the default setting.
This field indicates the time of day the display is to automatically turn itself on if
it is an active day. The value should be in a 24 hour format. The default setting
is 07:30.
This field indicates the amount of time the display is to be active for after the
display on time. The default setting is 10:30 (hours:minutes), so the display
would be turned off at 18:00 (6 pm).
This field indicates how long to wait before the display is turned off after the last
user activity. This timer gets reset after each interaction. The default setting is
01:00 (hours:minutes).
Indicates whether the phone will forward packets transmitted and received on the
phone port to the PC port.
This option determines if logs will be displayed or not.
A load server can be specified in IP format (x.x.x.x) if wanting to use an alternate
TFTP server for phone firmware downloads.
Determines if the recording tone is enabled or disabled. Default setting is
disabled.
The remote recording tone volume can be configured. This is on a 0-100% range,
where 100 is the default setting.
39