Record Setup - Akai RE32 Operator's Manual

RECORD SETUP

It is possible to select certain other options relating to recording in the RECORD SETUP page.
This is accessed by pressing SETUP (F3/F4) from the main record page:
The parameters are:
CROSSFADE
AUTO MONITOR
RECORD MODE
Version 1.00
This allows a record crossfade of 0 to 80ms to be set.
Here you may select how you will monitor the input signal. The default
selection is RECORD AND STOP. With this selected, you will hear the
input signal under the following conditions:
STOP
HEAR INPUT? YES
RECORD TRACK'S PLAY SELECT KEY ON
STOP
HEAR INPUT? YES
RECORD TRACK'S PLAY SELECT KEY OFF
The other selection you may make is RECORD ONLY. With this selected,
you will only hear the input signal whilst actually recording, regardless of
the status of the record track's PLAY select key. I.e.:
STOP
HEAR INPUT? NO
RECORD TRACK'S PLAY SELECT KEY ON OR OFF
RECORD ONLY is useful when you only ever want to hear the input
signal during record and at no other time. The system will take care of
the switching automatically.
This is a duplicate of the same parameter on the main record page which
allows you to select how the recordings you are about to make are stored
in the project.
RECORD PLAYBACK
YES NO
RECORD PLAYBACK
YES YES
RECORD PLAYBACK
YES NO
RECORDING
43