Table of Contents
Advertisement
NOTE 1: This page will only allow selection of sample rates that are supported on all the
connected machines.
NOTE 2: Recordings made at a sample rate other than the selected sample rate will play back
at the wrong speed. For example, if the sample rate is set to 44.1kHz and you try to play back
a recording made at 48kHz, the recording will play back slow. Therefore, please make sure
that your recordings are made at the correct sampling rate. Recordings made at different
sample rates cannot be used in the same project.
TC FRAME RATE
The SETUP page's soft keys take you to other pages where certain parameters that affect the
whole unit may be set. Not all of these are relevant for basic operation so, for the moment, we will
continue looking at other modes that are necessary for basic operation.
Version 1.00
This shows the system's timecode rate.
This field is not editable, but instead serves as a visual check that all
machines are configured correctly. If all machines are set to the same
frame rate, then this rate will be displayed here. If not, this field will say
"* DO NOT MATCH *".
Timecode frame rates can be individually set on each machine as
explained later in the section on TIMECODE SETUP.
GETTING STARTED
27
Advertisement
Table of Contents
