Table of Contents
Advertisement
Pressing BUTT (F2) on the main CROSSFADE TOOLS page gives you this screen:
METHOD
ADJUST
Having set the required parameters, press the EXECUTE key to proceed.
Pressing FADES (F3) on the main CROSSFADE TOOLS page takes you to the MODIFY FADES
screen in which you have individual adjustment of the PRE and POST fade characteristics:
The parameters on this page are:
LEVEL
TIME
CURVE
Version 1.00
Selects the method by which the BUTT is to be achieved .
With TRIM selected, one or both of the cues will be extended; this
assumes that the cue in question has a handle available for extension.
Note that the targeted cue turns yellow, while the passive cue stays
green.
SLIP (F2) selects SLIP as the method, which means that either the
PRE or the POST cue (not BOTH) is actually moved along the timeline.
SLIP IN can also be selected from within the TRIM page by pressing the
IN key while pressing SHIFT. Similarly, OUT + SHIFT selects SLIP OUT.
SLIP mode is clearly dangerous if working to picture, hence the cues in
question turn red in warning. Note that, when SLIP is selected F3
becomes active as SLIP? and toggles between slipping just the cue or
the entire track.
Selects which point(s) is to be adjusted:
PRE (F4)
Selects the PRE point for adjustment.
POST (F5) Selects the POST point for adjustment.
BOTH (F6) Selects both PRE and POST points foradjustment.
Adjusts the overall level of the selected cue
Determines the length of the fade.
Sets the curve characteristic.
EDIT TOOLS
97
Advertisement
Table of Contents
