Table of Contents
Advertisement
INTRODUCTION
SETTING MACHINE ID NUMBERS
When multiple machines are connected to the RE32, each must be assigned a unique MACHINE
NUMBER before the system is used for the first time. These must be assigned sequentially from 1
to the number of machines in the system and are used to allocate tracks to machines by the RE32.
Example 1:
Example 2:
Please refer to the machine's own operators manual for detailed information. The following is
intended to provide a brief description relevant to certain machines:
SETTING MACHINE ID NUMBERS - DR16pro
The DR16pro's MACHINE NUMBER assignment may be set as follows:
1.
Press the SUB-MENU key followed by the 3 (SETUP) key on the numeric keypad then
select AKAINET on the display by rotating the JOG/SHUTTLE control.
2.
Press the STORE/ENT key. The message MACHINE 01 will appear in the display showing
the current Machine ID.
3.
Use the JOG wheel to select the required Machine ID number and press the STORE/ENT
key to confirm the assignment and exit the menu.
SETTING MACHINE ID NUMBERS - DD8
The DD8's MACHINE NUMBER assignment is set on the AKNET INFO page which is accessed
from REMOTE page in the SYSTEM menus. On the front panel of the DD8, press the SYSTEM
key, followed by the MORE (F6) key then the REMOTE key (F2). Finally, press the AKNET key
(F1) and you will see the following screen:
The NUMBER field shows the MACHINE NUMBER currently assigned. You may change the number
using the DATA +/- keys and then save the new setting to flash ROM.
NOTE: Please refer to the operators manual provided with each machine for more detailed
information about setting MACHINE NUMBERs.
8
With two DR16pro machines:
Machine "1" =
Tracks 1-16
Machine "2" =
Tracks 17-32
With three DD8 machines:
Machine "1" =
Tracks
Machine "2" =
Tracks 9-16
Machine "3" =
Tracks 17-24
Note: DD8's front panel LCD
1-8
Version 1.00
Advertisement
Table of Contents
