Installation; Installing A Sim Card (Vc6096 Only) - Motorola VC6000 Series Quick Reference Manual

Quick Reference Guide

Installation

Installing a SIM Card (VC6096 only)

Before using the VC6096 in a cellular network, make sure that the
VC6096 is equipped with a Subscriber Identity Module (SIM) card,
obtained form your service provider. The SIM card is a small smart card
that fits into the VC6096. The SIM card holds the personalized
information about the VC6096, including network activation and phone
book entries.
To install the SIM card:
1. Remove the T8 screw that secures the SIM Card Door and open the
door.
2. Position the SIM Card with the contacts facing the back of the
VC6096, and insert into the SIM Slot. The SIM Card corner notch fits
into the slot only one way (See figure below).
3. Use a pen to push the SIM Card inwards to lock.
4. Place the SIM Card Door and secure the T8 Screw.
The VC6096 powers on only if the T8 Screw is fully secured.
NOTE
5. Torque the T8 Screw to 3.4 kgf-cm (3 in-lbs).
CAUTION
T8 Screw
Ensure to torque the T8 screw to seal the VC6096 Series
properly. Otherwise, sealing can be compromised.
SIM Slot
SIM Card
SIM Card Door
7