Motorola VC6000 Series Quick Reference Manual page 13

Quick Reference Guide
2. Plug connectors J2 and J3 to the telemetry receptacles of your vehi-
cle data bus.
3. Connect the I/O Wires as required
Telemetry Cable
J1 - To VC6000 Series Auxiliary port
I/O Wires: 8 digital inputs, 8 digital outputs, 2 analog
inputs, Debug (2 wires for debugging). See label on
wires. Maximum current through wires 0.5 A
For Input/Output (I/O) Wires connections, refer to the VC6000
NOTE
Series Product Reference Guide.
Grounding
CAUTION
Mounting the Combination Antenna (VC6096 only)
The Combination Antenna is an optional omni-directional WWAN and
WLAN antenna used with the VC6096. The antenna mounts
inside/outside the vehicle cabin or indoors/outdoors.
The antenna has two external RF connectors that connect to the
VC6096 via two low loss RF coax cables.
The VC6000 Series should operate only in negative
ground electrical systems. Check the ground polarity of
the vehicle before starting the VC6000 Series installation
to verify that the polarity is correct. Accidentally reversing
the polarity will not damage the VC6000 Series, but will
cause the cable fuse to blow.
.
J2 - RS232 Connector
11
J3 - Deutsch 6
pin Telemetry
Connector