Cleaning The Nozzle - 3D Printing Systems UP Mini User Manual

IMPORTANT NOTE: Before you enter any new calibration values, always click the
"Reset" button, otherwise the new values get added to the old ones. Before you "Reset" button, otherwise the new values get added to the old ones. Before you enter any "Reset" button, otherwise the new values get added to the old ones. Before you
new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg. new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg. new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg.
Next, take down the Front take down the Front Centre 'L' shaped component, and measure its
deviation. Put the exact value into the Z box. If it deviates to the right side, the deviation. Put the exact value into the Z box. If it deviates to the right side, deviation. Put the exact value into the Z box. If it deviates to the right side,
value to be put into the Z box will be a positive value. If the deviates to the left, be put into the Z box will be a positive value. If the deviates to the left, be put into the Z box will be a positive value. If the deviates to the left,
the value to put into the Z box will be a negative value. put into the Z box will be a negative value.
Finally, measure the height of Front Center component, which Finally, measure the height of Front
40mm if it is not scaled.
"Calibrate dialogue box. "Calibrate dialogue box.
Click "OK" to record all these values and exit the calibration window. Click "OK" to record all these values and exit the calibrat

Cleaning the nozzle

Cleaning the nozzle
After a lot of printing, the nozzle may be covered with a layer of oxidized ABS. After a lot of printing, the nozzle may be covered with a layer of oxidized ABS. After a lot of printing, the nozzle may be covered with a layer of oxidized ABS.
When the printer is printing, this oxidized ABS may melt on the nozzle, and may rinter is printing, this oxidized ABS may melt on the nozzle, and may rinter is printing, this oxidized ABS may melt on the nozzle, and may
create discolored spots the model. To avoid this you need to regularly clean the create discolored spots the model. To avoid this you need to regularly clean the create discolored spots the model. To avoid this you need to regularly clean the
nozzle.
Firstly, move the platform to the bottom, then do a Withdraw in order to move the platform to the bottom, then do a Withdraw in order to move the platform to the bottom, then do a Withdraw in order to heat the
nozzle to melt the oxidized ABS. the oxidized ABS.
Lastly, use some heat-resistant material, like 100 percent cotton cloth or soft
paper. A pair of tweezers will also be required. Then clip paper or some other paper. A pair of tweezers will also be required. Then clip paper or some other paper. A pair of tweezers will also be required. Then clip paper or some other
UP Mini 3D Printer User Manual 3D Printer User Manual
Before you enter any new calibration values, always click the Before you enter any new calibration values, always click the
Enter the exact measured value into the "H" box of the e exact measured value into the "H" box of the
resistant material, like 100 percent cotton cloth or soft resistant material, like 100 percent cotton cloth or soft
3. Operation Operation
, and measure its
, which should be
window.
42