3D Printing Systems UP Mini User Manual page 33

Area: The surface area above The surface area above which support material gets used. W
2
choose 5mm , for example, for example, there will be no support if the overhang
2
less than 5mm . Benefit? A little material is saved and a slightly . Benefit?
speed is achieved.
Other Options
Stable Support: Stable support creates support that is more solid, and the
model is less likely to distort, but the support material is then more difficult to model is less likely to distort, but the support material is then more difficult to model is less likely to distort, but the support material is then more difficult to
remove.
Tip: All setup and configuration settings are stored in the Up Software, not on All setup and configuration settings are stored in the Up Software, not on All setup and configuration settings are stored in the Up Software, not on
the Up Printer. This means that, if you change to a different computer, you the Up Printer. This m
will need to repeat all the calibration and setup procedures. will need to repeat all the calibration and setup procedures.
UP Mini 3D Printer User Manual 3D Printer User Manual
which support material gets used. When you
there will be no support if the overhanging area is
table support creates support that is more solid, and the table support creates support that is more solid, and the
eans that, if you change to a different computer, you
3. Operation Operation
slightly faster print
33