Tray 2 Solenoid (Pl 9.1.28); Tray 2 No Paper Sensor (Pl 9.3.44) - Xerox Phaser 3425 Service Manual

Replacement Notes
Note
A ground wire and a discharge capacitor are secured to the Main Drive
Assembly by 2 of the mounting screws. Note the position for reassembly.
Note
Seat the right side of the Main Drive first, then work the left side into
position while aligning the gears. Reattach the Cover Interconnect Board
after the Main Drive is positioned.

Tray 2 Solenoid (PL 9.1.28)

1. Remove the Main Drive Assembly (page 8-19).
2.
Disconnect CN 10 between the Tray 2 Solenoid and the Connector Board.
3.
Remove 2 screws that secure the Tray 2 Solenoid to the chassis, and remove the
Tray 2 Solenoid.

Tray 2 No Paper Sensor (PL 9.3.44)

1.
Remove the left cover from the printer (page 8-8)
2.
Disconnect CN 2 (to Registration Sensor) from the sensor board.
3.
Disconnect CN 3 (to Print Cartridge Interconnect Board) from the sensor board.
4.
Remove 2 screws securing the Tray 2 No Paper Sensor to the printer chassis and
remove the sensor.
Service Parts Disassembly
1
-
8-21