Advanced Operation - American Dynamics illustra 400 Installation & Operation Manual

6. ADVANCED OPERATION

Question 1:
How can I view the live images of the IP camera via Microsoft Internet Explorer on the
Desktop PCs, or the laptop computers, in a situation where there are no monitors or
television?
◇ To get the IP address of the IP camera without a monitor, use one of the following two methods
to get the IP address: UPnP and USB function.
UPnP: Please refer to APPENDIX A.
IP function: Please refer to 2.7 The USB function.
Question 2:
How to activate UPnP?
1. Follow the default settings to set up the related settings, and connect the hardware.
2. Activate the Web browser and key in the camera URL.
3. SETUPNetwork button.
4. Select "Enable UPnP presentation".
5. Select "Enable UPnP port forwarding"; make the "Forwarding Port" setting.
NOTE:
1. Perform the step 4 above; turn on the PC's "My Web Neighbors" and confirm if the camera
can be found, and click to go online to the camera's first page.
2. Perform the step 5 above; make the Route UPnP port forwarding setting.
3. The PC-online-to-Router IP can go online to the camera webpage via the Router.
Question 3:
How to change the Video Profiles 1, 2, 3?
1. Plug the power cable into the IP camera power connector.
2. Plug the network cable into the IP camera Ethernet terminal.
3. Confirm the web-connection status; the connection between the PC & HUB and between
the IP camera & HUB is now activated.
4. Confirm that the IP addresses of the PC and the IP camera are in the same sub-net.
5. Activate the Web browser and key in the IP camera's URL.
6. Switch to the front-page of Live; click Profiles 1, 2 & 3.
88 Installation and Operation Guide