Figure 5.19 Pppoe Settings - American Dynamics illustra 400 Installation & Operation Manual

 Change the Network Setting — PPPoE.
The "Network" page has, on its upper left, the "PPPoE" icon. Please follow the steps below to change the
PPPoE setting through the network as necessary.
Click on the PPPoE button on the upper left menu to enter the "PPPoE Settings" page.
1.
2. Click on the Enable or Disable button to set the PPPoE Settings status.
Enter the PPPoE "Username" and the PPPoE "Password", then confirm the password again.
3.
4. Click on the Submit button to submit the new setting.
NOTE: Please refer to section 5.1.3.8 (PPPoE & DDNS) for more details.
Description of function keys:
PPPoE Setting
Username:
Password:
54

Figure 5.19 PPPoE Settings

If you use the camera to connect directly to the Internet, you will need to
enter the username and password, which were given to you when you set
up your account with your Internet Service Provider. If the camera is
behind a router or a gateway, you do not need to configure this setting.
Enter it in the given space.
Enter it in the required space.
Installation and Operation Guide